Re: Proper blaster config in this file?

On 22/03/17 12:02 PM, Bengt Martensson wrote:
> On 03/22/17 17:45, John Adams wrote:
>> On Wed, 22 Mar 2017 15:42:31 +0100
>> Bengt Martensson <[email protected]> wrote:
>>
>>> Yes, I can tell you. The signals are RCMM or Nokia32. This does not
>>> decode one bit at a time on one of two bursts (ZERO and ONE), but
>>> decodes TWO bits at one of four bursts (ZERO, ONE, TWO, THREE). IIRC,
>>> Lirc can handle this on reading, but it was never implemented for
>>> sending.
>>>
>>> Other than this, the files are fine, and import without problems in
>>> IrScrutinizer.
>>>
>>> Greetz,
>>>
>>> Bengt
>> I have been using RCMM sending with lirc for the last couple of years.
>> It works perfectly for me (after I blocked the nearby mirror
>> reflection).
> Hmm, man lircd.conf(5) sez:
>
>
>      RCMM
>              The remote uses the RC-MM protocol (transmitting not supported).
>
> so at least one is not "telling the truth". We should clarify.
>
> Greetz,
>
> Bengt
>
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
That would be good.  Can anyone that is successfully transmitting 
confirm what protocol ( and if they are using RCMM ) they are using.

Maybe share their config file would be great.

Thanks,

Mark

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot