Re: Proper blaster config in this file?

On Wed, 22 Mar 2017 19:02:45 +0100
Bengt Martensson <[email protected]> wrote:

> On 03/22/17 17:45, John Adams wrote:
> > On Wed, 22 Mar 2017 15:42:31 +0100
> > Bengt Martensson <[email protected]> wrote:
> >
> >>
> >> Yes, I can tell you. The signals are RCMM or Nokia32. This does not
> >> decode one bit at a time on one of two bursts (ZERO and ONE), but
> >> decodes TWO bits at one of four bursts (ZERO, ONE, TWO, THREE).
> >> IIRC, Lirc can handle this on reading, but it was never
> >> implemented for sending.
> >>
> >> Other than this, the files are fine, and import without problems in
> >> IrScrutinizer.
> >>
> >> Greetz,
> >>
> >> Bengt
> >
> > I have been using RCMM sending with lirc for the last couple of
> > years. It works perfectly for me (after I blocked the nearby mirror
> > reflection).
> 
> Hmm, man lircd.conf(5) sez:
> 
> 
>     RCMM
>             The remote uses the RC-MM protocol (transmitting not
> supported).
> 
> so at least one is not "telling the truth". We should clarify.
> 
> Greetz,
> 
> Bengt
> 
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot

When I first started to use RCMM sending, I too read the manual and the
comment in the code.  So I set out to fix it.  To my surprise, it
wasn't broken.

Its easy to see who's "telling the truth".  Read the source., dude.
I use lirc 0.9x running entirely in user space.

-- 
John Adams (lirc-vJAWjL9BI9pWk0Htik3J/[email protected])

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot