Re: LIRC using with directly wiring the endpoints.
Bengt Martensson <[email protected]>
| Newsgroups | gmane.comp.hardware.lirc |
|---|---|
| Message-ID | <[email protected]> |
On 10/22/17 14:36, Raj Panchal wrote: > Thank you Bengt: > > To test out IR HW bypass, first I'm using two RPI3, connecting the GPIO22 and ground pins on RPI3-TX TO GPIO23 and ground RPI3-RX. I added "frequency 0" to the lircd.conf which was originally generated using the irrecord utility.. I'm not using the optocoupler. Does the "invert=on" invert the waveform completely or should I manuallymodify in the lircd.conf? Since there is no remote control there is no need to invert to save battery power. I do not know what "invert=on" is. You need to invert if you are emulating a standard demodulating receiver, TSOP-**** for example, as I think I wrote in the quoted Arduino-IRremote issue. It has nothing to do with saving power. "Top posts" are frowned upon in this community. Greetz, Bengt ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot