Re: Regarding issue with mode2 data generation and IR recording

On 6/27/19 6:48 AM, sabeer sam wrote:
> Respected one,
> I tried the way you told to do for recording the values, but am getting 
> same results. I covered the sensor and also placed a 100nf capacitor in 
> between plus and ground, but still it's throwing random values when I 
> run mode2 command before pressing the button

If you get pulses when the sensor is in absolute darkness your hardware 
is broken. Replace. Use high-quality products for example Vishay, avoid 
low-cost junk.

 > and when I start recording
> the button values am getting different values each time.

As I wrote before, this is normal (within limits).

Without any more details, there is no way to help. Photos perhaps?

Greetz,

Bengt