Re: Weirdness when trying to send commands to a Samsung TV

You want to analyze the output when RPi A (tries to) send the signal 
with, say, 3 repeats. For this you can use IrScrutinizer; if you do not 
"like" running on the RPi you can use a PC (Linux, Windows, Mac). Or mode2.

On 2019-11-05 22:35, Sahbi via LIRC-list wrote:
> Using a gap value lower than 80000 only results in "transmission failed" 
> or "buffer too small" errors, anything >= 80k and <= 150k unfortunately 
> doesn't make a difference either.
> 
> I checked both lircd -h and man lircd and I don't see any mention of 
> increased verbosity for logging. Also apparently OSMC recently updated 
> their distro to use kernel 4.19.55-6 but upgrading to that too doesn't 
> help.
> 
> I personally don't like having a GUI on my Linux boxes, so I don't think 
> I can use IrScrutinizer at all? I ran mode2 (without -m because I think 
> that gives a bit less information) to capture the output of a SEND_ONCE 
> for volume down from Pi A:
> pulse 4571
> space 4543
> ...