config file for Spectrum DVR 210-H
"Matthew Ward" <[email protected]> Sat, 22 Feb 2020 09:11:10 -0600
| Newsgroups | gmane.comp.hardware.lirc |
|---|---|
| Message-ID | <[email protected]> |
after a lot of procrastination, i finally worked out the config file to command via IR the Spectrum DVR supplied with my latest cable installation. i don't recall how (if?) to upload configs to <some repository>, so here is a copy. the system thinks it's a "Spectrum210H" although all of the manufacturer tags say Humax ... so not sure how to list this. Spectrum? Humax? all i know is: it works.
spectrum-humax-210h.conf
(application/octet-stream, 2 KB)
#
# this config file was automatically generated
# using lirc-0.9.3(default) on Tue Dec 31 08:49:56 CST 2019
#
# contributed by WaldoTJ
#
# brand: Humax
# model no. of remote control: MG3-1160
# devices being controlled by this remote: Spectrum 210-H
# this is the DVR/cable receiver from Spectrum Cable
#
begin remote
name spectrum
bits 22
flags SPACE_ENC|CONST_LENGTH
eps 30
aeps 100
header 3375 3323
one 866 2485
zero 866 791
ptrail 876
gap 100211
toggle_bit_mask 0x0
begin codes
1 0x36113D
2 0x37111D
3 0x36912D
4 0x37910D
5 0x365135
6 0x375115
7 0x36D125
8 0x37D105
9 0x363139
0 0x373119
BACK 0x3E7031
OK 0x366133
OPTIONS 0x3E882E
RECORD 0x375914
MENU 0x373918
EXIT 0x366932
CURSOR_UP 0x36812F
CURSOR_DOWN 0x37A10B
CURSOR_LEFT 0x37810F
CURSOR_RIGHT 0x364137
GUIDE 0x36C127
INFO 0x36213B
CHPG+ 0x377111
CHPG- 0x36F121
MENU_DVR 0x36C926
PAUSE 0x3E083E
SEARCH 0x3F081E
POWER_TOGGLE 0x37C107
REVERSE 0x37291A
PLAY 0x37990C
FF 0x36293A
STOP 0x365934
PREV 0x36E123
end codes
end remote