Re: config file for Spectrum DVR 210-H

On 2020-02-22 16:11, Matthew Ward wrote:
> after a lot of procrastination, i finally worked out the config file to 
> command via IR the Spectrum DVR supplied with my latest cable installation.
> 
> 
> 
> i don't recall how (if?) to upload configs to <some repository>, so here 
> is a copy.

You can make a Git pull request to 
https://sourceforge.net/projects/lirc-remotes/ , but, frankly, I doubt 
that it is a good idea, there are already unprocessed ones more than a 
year old ;-/

> the system thinks it's a "Spectrum210H" although all of the manufacturer 
> tags say Humax ... so not sure how to list this. Spectrum?  Humax?


http://irdb.globalcache.com/ knows a settop box from manufacturer 
"Spectrum" called "201-H Cable Receiver" so I guess that your name is 
not completely off.

I run your file through IrScrutinizer, and it did not decode. I 
downloaded the data from GlobalCache as above, (which did decode as 
Panasonic_Old, with modulation frequency of 58kHz). Turned out that your 
codes are identical (up to measurement errors) to theirs! So it is quite 
possible that it should be 58kHz instead of the 38kHz implied by no 
FREQUENCY in the Lirc file.

> all i know is:  it works.

Possibly less reliably than with correct frequency.