Re: STM32F1 USART1
Uwe Bonnes <bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org>
| Newsgroups | gmane.comp.hardware.microcontrollers.ethernut |
|---|---|
| Message-ID | <[email protected]> |
>>>>> "Achim" == Achim <[email protected]> writes: Achim> Hi Uwe, I think there´s a further mistake in the F1 USART: Achim> independent of the selection of "Use alternate Pins" in qnutconf, Achim> the pins are always remapped to port B. I realized this when Achim> debugging into Stm32UsartInit(). USART_TX and USART_RX have the Achim> values PB06 and PB07! Unfortunately I´m not familiar enough with Achim> the configuration process to find the mistake. But i think that Achim> somewhere "USART1_REMAP" (used in stm32_usart_pinmux.h) is Achim> defined even if no remapping is selected. Again, you don't answer my pending question but instead you bring up another problem without any hard information. How should I reproduce your problem without having the .conf file you use? USART1_REMAP is generated by running the configurator in include/cfg/uart.h. Did you run the configurator after the last changes to either the .conf file or SVN? Bye -- Uwe Bonnes bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org Institut fuer Kernphysik Schlossgartenstrasse 9 64289 Darmstadt --------- Tel. 06151 162516 -------- Fax. 06151 164321 ---------- _______________________________________________ http://lists.egnite.de/mailman/listinfo/en-nut-discussion