Re: Detecting link state

Hi Philipp,

which platform are you using? I implemented a link state detection in
several projects running on the LPC plattform.

But as the code mainly uses PHY communication it should run with any
plattform with external PHY.

Later today I'll have access to the code and can send you an example.

Best regards,

Ole Reinhardt

Am 10.07.2018 um 10:43 schrieb Philipp Burch:
> Hi everyone,
> 
> is there a good way to detect if an Ethernet link has been established
> when using Ethernut? I see that this has been discussed in the past, but
> could not find any outcome:
> 
> http://microcontrollers.2385.n7.nabble.com/detecting-an-unplugged-network-cable-td160042.html
> 
> Thanks.
> 
> Best regards,
> Philipp
> _______________________________________________
> http://lists.egnite.de/mailman/listinfo/en-nut-discussion
> 

-- 
Embedded-IT
Alter Weg 3
57223 Kreuztal
http://www.embedded-it.de

Tel.: +49-177-7420433
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion