Re: Detecting link state

Hi Ole,

it's for the TIVA microcontrollers, which have an integrated PHY. But as
far as I remember, it is used the same way as an external standard PHY.

Thanks!

Best regards,
Philipp

On 21.07.2018 13:41, Ole Reinhardt wrote:
> Hi Philipp,
> 
> which platform are you using? I implemented a link state detection in
> several projects running on the LPC plattform.
> 
> But as the code mainly uses PHY communication it should run with any
> plattform with external PHY.
> 
> Later today I'll have access to the code and can send you an example.
> 
> Best regards,
> 
> Ole Reinhardt
> 
> Am 10.07.2018 um 10:43 schrieb Philipp Burch:
>> Hi everyone,
>>
>> is there a good way to detect if an Ethernet link has been established
>> when using Ethernut? I see that this has been discussed in the past, but
>> could not find any outcome:
>>
>> http://microcontrollers.2385.n7.nabble.com/detecting-an-unplugged-network-cable-td160042.html
>>
>> Thanks.
>>
>> Best regards,
>> Philipp
>> _______________________________________________
>> http://lists.egnite.de/mailman/listinfo/en-nut-discussion
>>
> 
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion