Re: Working Windows build?

I tried stm3210e-eval.conf and stm3240g-eval.conf. Always the same: the mak=
edes and makerules cannot be found. =

Besides, I currently want to build the predefined ethernut50f.conf file, si=
nce I use that board.

Best regards,
   Nikolas

-----Urspr=FCngliche Nachricht-----
Von: en-nut-discussion-bounces-inJ12LbcDfezQB+pC5nmwQ@public.gmane.org [mailto:en-nut-discussion-bounces@=
egnite.de] Im Auftrag von bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org
Gesendet: Dienstag, 31. M=E4rz 2020 10:49
An: Ethernut User Chat (English) <[email protected]>
Betreff: Re: [En-Nut-Discussion] Working Windows build?

Nikolas Becker writes:
> I did the same, manually setting the PATH beforehand and running qnutconf=
 from an administrator shell.
> Now it tries to build but immediately stops:
> 09:56:31: makefile:38: =

> D:/dev/trunk/Ethernut/ethernut_2020_03_30/nut/Makedefs.: No such file =

> or directory
> 09:56:31: makefile:51: =

> D:/dev/trunk/Ethernut/ethernut_2020_03_30/nut/Makerules.: No such file or=
 directory Here is my nut-Folder, copied out of the explorer, so this is fo=
r sure correct:
> D:\dev\trunk\Ethernut\ethernut_2020_03_30\nut
> And yes, the Makedefs. And Makerules.-files are there. =

> I tried to change the /-Signs to \-Signs, but that doesen't change anythi=
ng.
Please try first with some of the predefined STM32 conf files in nut/conf.

-- =

Uwe Bonnes                bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org

Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
--------- Tel. 06151 1623569 ------- Fax. 06151 1623305 --------- _________=
______________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion