Re: Working Windows build?

Nikolas Becker writes:
> I tried stm3210e-eval.conf and stm3240g-eval.conf. Always the same:
> the makedes and makerules cannot be found.   
> Besides, I currently want to build the predefined ethernut50f.conf
> file, since I use that board. 
> 
Did you try pure nutconfigure? For a given configuration, nutconfigure
is the easiest way to go. qnutconf is only helpfull if you want to
setup/change a configuration in a graphical way with online help on
the configuration items.

It boils down to create the tree
$(NUTCONFIGURE) -c $(CONF) -s $(NUTSOURCE) -u . create-buildtree
$(NUTCONFIGURE) -c $(CONF) -s $(NUTSOURCE) -u . create-usertree

But anyway, the qnutconf issues should get fixed...

Bye
-- 
Uwe Bonnes                bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org

Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
--------- Tel. 06151 1623569 ------- Fax. 06151 1623305 ---------
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion