Re: Working Windows build?
Nikolas Becker <[email protected]> Tue, 31 Mar 2020 11:45:11 +0000
| Newsgroups | gmane.comp.hardware.microcontrollers.ethernut |
|---|---|
| Message-ID | <[email protected]> |
Hi Uwe, = I tried: Nutconfigure -c nut/conf/ethernut50f.conf -s /nut -b /nutbld -m arm-gcc cre= ate-buildtree And several other folder combinations. It gives: nutconfigure 2.0.10 Loading ./nut/conf/repository.nut...OK Loading nut/conf/ethernut50f.conf...OK Creating Makefiles for arm-gcc in /nutbld...OK Creating header files in /nutbld...OK Then I tried to run make in the nutbld-folder. It gives: make -C arch make[1]: Entering directory `D:/dev/trunk/Ethernut/ethernut-head/nutbld/arc= h' makefile:38: /nut/Makedefs.avr-gcc: No such file or directory makefile:52: /nut/Makerules.avr-gcc: No such file or directory make[1]: *** No rule to make target `/nut/Makerules.avr-gcc'. Stop. make[1]: Leaving directory `D:/dev/trunk/Ethernut/ethernut-head/nutbld/arch' make: *** [all] Error 2 Any advice? Best regards, = Nikolas -----Urspr=FCngliche Nachricht----- Von: en-nut-discussion-bounces-inJ12LbcDfezQB+pC5nmwQ@public.gmane.org [mailto:en-nut-discussion-bounces@= egnite.de] Im Auftrag von bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org Gesendet: Dienstag, 31. M=E4rz 2020 11:39 An: Ethernut User Chat (English) <[email protected]> Betreff: Re: [En-Nut-Discussion] Working Windows build? Nikolas Becker writes: > I tried stm3210e-eval.conf and stm3240g-eval.conf. Always the same: > the makedes and makerules cannot be found. = > Besides, I currently want to build the predefined ethernut50f.conf = > file, since I use that board. > = Did you try pure nutconfigure? For a given configuration, nutconfigure is t= he easiest way to go. qnutconf is only helpfull if you want to setup/change= a configuration in a graphical way with online help on the configuration i= tems. It boils down to create the tree $(NUTCONFIGURE) -c $(CONF) -s $(NUTSOURCE) -u . create-buildtree $(NUTCONFIGURE) -c $(CONF) -s $(NUTSOURCE) -u . create-usertree But anyway, the qnutconf issues should get fixed... Bye -- = Uwe Bonnes bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org Institut fuer Kernphysik Schlossgartenstrasse 9 64289 Darmstadt --------- Tel. 06151 1623569 ------- Fax. 06151 1623305 --------- _________= ______________________________________ http://lists.egnite.de/mailman/listinfo/en-nut-discussion _______________________________________________ http://lists.egnite.de/mailman/listinfo/en-nut-discussion