Re: Couple of questions

Jeff <[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.gnupic
Message-ID <[email protected]> 
On Monday 01 August 2005 04:29 am, Julian Green wrote:
> Can I use picp and the picstart programmer to program a PIC18F2550?

18F2550 is not currently supported by picp. If you can capture the processor 
definition data using picsnoop or other utility, then I can add it to 
picdev.c.
>
> Does anyone know of code examples of how to drive the USB interface?
>

Picp works with USB to serial interfaces.

Jeff
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.