Re: Couple of questions
Julian Green <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.gnupic |
|---|---|
| Message-ID | <[email protected]> |
On Mon, 1 Aug 2005, Jeff wrote: > > On Monday 01 August 2005 04:29 am, Julian Green wrote: > > Can I use picp and the picstart programmer to program a PIC18F2550? > > 18F2550 is not currently supported by picp. If you can capture the processor > definition data using picsnoop or other utility, then I can add it to > picdev.c. > > > > Does anyone know of code examples of how to drive the USB interface? > > > > Picp works with USB to serial interfaces. Sorry - dont think I worded the question very well. The PIC18F2550 has a USB interface, and I want to use it in an application. Does anyone know of example code to drive the interface? I was thinking on the lines of a serial port as the SW drivers for the other end are common. > > Jeff > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] >