Re: [EE] Cyclic torque loads on AC motors?

David Robertson <[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.pic
Message-ID <CACyjwT2JkvxyCWGfnzXgfo9YRShyto4Sr9WKzgNug2jiUVVKcg@mail.gmail.com> 
Would a big heavy flywheel not help?

On Sun, 8 Dec 2024, 08:28 Jason White, <[email protected]>
wrote:

> I do intend to direct-drive the piston.
>
> Years ago I disassembled a commercial compressor pump that did this with a
> single phase motor. (Now, only if I could remember why I was taking it
> apart... I think it was because it had developed a crack in the housing of
> the cylinder body casting... that bodes well for my scheme)
>
> I would like to think if the load and vibration is small enough, that one
> might be able to get away with direct drive. I might be proven wrong.
>
> --
> Jason White
> --
> http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
> View/change your membership options at
> https://mailman.mit.edu/mailman/listinfo/piclist
>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.