Re: Flash
Thomas Chenot <tom.chenot-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
I will assume you are using the correct TINI400 commandline, "JavaKit -400 -flash 40". I recently had this problem and it turned out that the module was not seated properly in the socket. Try removing and then reseating the module. James Alan Umstot wrote: >I've attempted to load 1.12 final onto two DSTINIM400s running 1.12p12. > >When loading I get CRC errors. I assumed this meant I had a bad connection. >However upon repeated attempts, I was still unable to load tini_400.jar. I >took a new DSTINIM400 out of the box and had no trouble loading 1.12 final. > >My first guess is that the network settings which were commited to flash >aren't being erased. However, it was my understanding that the flash is >Zapped as a bank. > >I was told that the Loader is stored on a ROM, so I shouldn't be able to >scrog the system beyond recoverability. So far, however, I have been unable >to bring these TINIs back to a functioning state. > >Any Advice? >Jim > > -- Thomas Chenot _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini