Re: PHY Address & Netboot
Robert Muchsel <robert.muchsel-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Netboot might be a problem (the DS80C400 ROM Netboot code contains an early revision of the PHY code that has problems with more than one PHY, and IDs other than 0). Please contact me off-list with a more detailed description of your design if you need a more precise answer. (Note that the restrictions mentioned above don't apply to the C libraries and the TINI runtime.) Robert On Mon, 2004-01-12 at 09:29, Michael Wurm wrote: > Hi, > > I'm designing a board using DS80C400 with an alternative > Ethernet-PHY. > I have to hardwire the PHY's address, but when I set it to 00000, > the PHY enters isolate-mode automatically after reset. > > Will the NetBoot also work with a PHY at a different address or > clear the isolate-bit? -- Robert Muchsel - Dallas Semiconductor - http://www.maxim-ic.com/TINI/ _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini