changing PHY mode in software
"Nathan Gustavson" <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Our DS400 carrier board hard codes it's ethernet to 10base-T half-duplex no-negotiation. We would like to be able to change this mode via software, looking over the PHY PDF it appears possible. Has anyone done this before, any example code out there? Thank you, Nathan Z. Gustavson Embedded Engineer EMAC, Inc. 2390 EMAC Way Carbondale, IL 62902 Phone (618) 529-4525 ext 320 Fax (618) 457-0110 Website: http://www.emacinc.com _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini