Re: Embedded DS80C400 Silicon Software
"Kris Ardis" <Kristopher.Ardis-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <002401c3db6d$0b0019a0$764000b4@kardis> |
> "rom_init function ... prints the opening message" (i.e. "DS80C400 Silicon > Software" or "-Copyright (C)"). > I understand it is printed using serial port, but: > - which DS80C400 serial port (0, 1 or 2)? Serial 0 > - which mode (0, 1, 2 or 3)? > - what baudrate? You can setup serial 0 however you like. For projects developed in Keil, this is done near the end of the startup400.a51 file, where we set it up for 115200 in mode 1. Kris _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini