SMD soldering (off topic)
Tom Blough <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <C0AB12EEC12BD51187F300010331CB7C4CA9A2@FM_2> |
I know some of you out there are hardware guys and were wondering if anyone had any pointers on hand soldering surface mount devices. I'm going to make a few boards to play with some of the 1-wire devices and have never done SMDs before. I'm thinking of supergluing (any problems with the superglue electrical wise?) the chip down, fluxing the leads, and then heating and applying solder to the pads (0.015 tip and solder). Will this work? Any other methods for hand soldering? TIA, Tom Blough _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini