1-Wire LCD Hardware?

I've been using this tini hardware for 1 week tomorrow and I have to say I
like it.  I have spent some time learning the 1-Wire interface and was
wondering if there exists a 1-Wire LCD interface that supports the basic 14
pin LCDs that are available.  I saw in the archives one mentioned and of
course the website isn't available etc...  I know I could roll my own using
a ds2408 but I was wondering if anyone knew were you could get a hold of one
that was already done and fairly inexpensive.  I found the CLCD which
claimed to be a one wire LCD controller with 5 GPIO pins until I read the
fine print and found it wasn't dallas 1-wire compatible at all.

My end result is I simply want to interface an LCD to my tini board in the
easiest way possible.  I would like to be able to take it off and put it
back in the easiest way possible so if someone has a solution other than
1-Wire I would be up for that as well.

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini