RE: native driver for P5.4?

Check out Port 5 Control Register (P5CNT) on page 32 of the High-Speed
Microcontroller User's Guide: DS80C400 Supplement.  You must set up these
pins to be GPIO here.

http://pdfserv.maxim-ic.com/arpdf/Design/DS80C400UG.pdf

Jeremy

> -----Original Message-----
> From: tini-admin-6tN4nzCoH/[email protected] [mailto:[email protected]]On Behalf Of
> Koen Swinters
> Sent: Monday, January 26, 2004 7:00 AM
> To: tini-6tN4nzCoH/[email protected]
> Subject: [TINI]native driver for P5.4?
>
>
> Im writing a native driver for controlling some external component. This
> component is connected to P5.4, P5.5, P5.6, P5.7 and P3.7(other pins are
> in use for other things). When I try to toggle the Pins on P5(090h), the
> pins wont toggle? when I try the same code on pin 1 of P1(0A1h) it
> works, the pin P1.1 toggles.
> How can I toggle pins on port 5?
>
>
> Koen
>
>
> _______________________________________________
> TINI mailing list
> TINI-6tN4nzCoH/[email protected]
> To UNSUBSCRIBE, edit your profile, or see list archives:
> http://lists.dalsemi.com/mailman/listinfo/tini

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini