Re: native driver for P5.4?
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Koen Swinters wrote: > Im writing a native driver for controlling some external component. This > component is connected to P5.4, P5.5, P5.6, P5.7 and P3.7(other pins are > in use for other things). When I try to toggle the Pins on P5(090h), the > pins wont toggle? when I try the same code on pin 1 of P1(0A1h) it > works, the pin P1.1 toggles. > How can I toggle pins on port 5? Check out the CPU documentation on P5CNT. P5.4-P5.7 can be configured as chip enables, or as general purpose I/O. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini