Re: CAN bus mask problem
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Qaisar Ahsan wrote: > I am using TINI390 for extended CAN with 29 bit identifier. I am facing a > strange problem. The global mask is acting as 11 bit only although i am using > the method set29BitGlobalIDMask. > > The bus works well for a 29 bit ID match. It also works well if an ID mismatch > occurs in 11 bits (masked), but do not mask the other 18 bits. What version of firmware are you using? Verify that your program uses the following function: set29BitMessageCenterArbitrationID() I haven't seen this problem before, please send the smallest amount of code that reproduces this problem. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini