RE: RS232

Note that a direct write to the transmit pin is possible.  This is how send
break is implemented.  You could write your own native routine to handle
sending the wave, or use bit port to do the same.

Jeremy

> -----Original Message-----
> From: tini-admin-6tN4nzCoH/[email protected] [mailto:[email protected]]On Behalf Of
> Andreas Skaar
> Sent: Friday, January 30, 2004 9:19 AM
> To: tini-6tN4nzCoH/[email protected]
> Subject: [TINI]RS232
>
>
> >Just curious, are you trying to get data across the wire quicker
> or what?
> >Get rid of stop!
>
>
> I'm using the UART to create a wave, which is sent to a chip. The
> problem is
> that I want to send a longer period of 0 volts and the start bit
> makes this
> impossible.
>
> I have heard that there used to be a special char or signal the
> UART could
> send which did not have a start bit.
>
> Is any thing like that possible with TINI?
>
>
> Andreas
>
> _________________________________________________________________
> It's fast, it's easy and it's free. Get MSN Messenger today!
> http://www.msn.co.uk/messenger
>
> _______________________________________________
> TINI mailing list
> TINI-6tN4nzCoH/[email protected]
> To UNSUBSCRIBE, edit your profile, or see list archives:
> http://lists.dalsemi.com/mailman/listinfo/tini

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini