External Flash *Err*
"Ferran Balaguer Del Pozo" <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Hello: I'm developing a system that require an external flash for the TINI 390 board.The memory is the recomended AM29f040b. When I try to program the memory, the message is this: B8 T1 0 0 *Err* *Err* The Bank 0 protection is disabled and I can execute the comman Z8 successfully. The chip enable signal works fine and the JavaKit options ROMSize 1048576 and -allow are enabled. The schematic is the same that the TINI Socket Rev.C. Can anyone help me? Bests regards. Ferran _________________________________________________________________ Una mejor experiencia en Internet. Prueba gratis dos meses MSN 8. http://join.msn.com/?pgmarket=es-es&XAPID=1577&DI=1055&HL=TAGExternalPrueba2mesesgratis _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini