Re: Power Supply
Thomas Chenot <tom.chenot-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Walter Schilling wrote: >I just got the HW and I have started setting-up a development machine. > >The TINI doc insert that came with the HW says 5VDC 300mA and the Getting >Started web site says to use the 5VDC 150mA Radio Shack P/N 900-2740. >Radio Shack doesn't know this P/N. > >Would the 5VDC 2.0A that I currently have, damage the TINI board? > No (assuming you observe the correct polarity). The 2.0A rating is the maximum AVAILABLE current of your power supply. The hardware dictates the actual current used. > >Pax et bene, > >Walt >_\/\/ _/-\ |_ -|-_ >~~~_/)~~~ > > > > > -- Thomas Chenot _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini