ethernet problem

I have build a new tini board(with DS80C400). Everything is working
except for the communication with ethernet. I have used the phy
LXT972ALC. I have checked the connections on the new board and they are
the same as on the  demo board.
When I ping from slush to his own address I get the following
information:

TINI /> ping 192.168.0.146

Reply from node 192.168.0.146/192.168.0.146 (1ms)

Sent 1 request(s), got 1 reply(s)

So loopback is working.
Does this mean that I have communication with the LXT972ALC?

When I ping to a computer on the same network I got the following
information:

TINI /> ping 192.168.0.147

Node 192.168.0.147/192.168.0.147 was unreachable

Sent 1 request(s), got 0 reply(s)

When I try to ping the board it is also not reachable.

non of the LEDS are burning (TX or RX or link)

Is there a way to test if the LXT972ALC is working (connections with the
DS80C400)?

Regards,

Koen


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini