which crystal frequency should be used to calculate CAN baud rate?

"Charles Chao Wang" <chao_wang99-/[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.tini
Message-ID <[email protected]> 
Hi,

I am useing TINIs400 and TINIm400, and I am doing CAN bus. I know the baud
rate is calculated as:

baud rate (bits per second) = 18.432 x 10^6 / BRP / (1
+ TSEG1 + TSEG2)


But in TINIm400, we should use 18.432MHz or 25MHz. I find the cystal is
25MHz on the schematic.

Please help~~~~~~~~, I am on my final project.

Thanks a lot.

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.