How do I get rw-access to my flashes during high speed 75 MHZ??

Hello everybody,

I wanted to use a fast 75 Mhz clock for my tini (DS80C400). Therefore I 
use the networkcamera design as a basic schematic.
On Bank CE4- CE7 I wanted to put on each two AM29LV081-70EC (1Mx8Bit, 
70ns) Flashes for data storage purposes. If I want to have access to 
that flashes after booting, how do I do that from JAVA?

Is the
public void setStretchCycles(byte stretch) throws IllegalArgumentException
public int getStretchCycles()

commands decribed in the tini-spec on page 189 the right command to do 
set the delay? They only mentioned stretch cycles for the databus, but I 
also need valid data for the address bus. Is this done by this command, 
too. Or if not, what is the alternative way in getting access read and 
write during high speed??

Hope one can help me,

regards
Peter

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini