Re: Interface with TINIM400
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Theeraputh Mekathikom wrote: > Dear all, > I'm about to communicate with Tini board. First, I > tried serial port but it seems that 115200 baud is not > enough for my application. I wonder is there any other > way to interface faster with TINIM400 (i.e. parallel) > ? or can I simply increase baud rate? Theeraputh, You can attach your device to the /PSEN, /WR, data, and a chip enable (/CE4-/CE7) and move data as fast as a movx instruction will allow which at ~29MHz is 1.8Mbytes/sec. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini