Re: Code Startup
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Saurabh wrote: > while other board has DS80C400 0336B1 0261A FNY, which at power on, doesn't > execute the PPPClient..I have to invoke the bootloader, select respective > bank (B 40) and then issue execute command (X) through boot loader...Then > only TINIOS starts and application starts runining...After invoking boot > loader (by default Bank selected is C0), if exit command (E) is issued, code > halts and gives error message no User application found.. Since you have a 2MByte flash, you should check and make sure no flash banks are used above 47. Clear the other flash banks and see if it fixes the problem. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini