Re: Error in Multibank Load

Dear Xavier,

Thanks for your help. 

I would really appreciate if you could send me the C file for breaking the
programs into parts. Regarding Macro's in Javakit, I am not too sure. Can
you point me to right documentation for the same?  (This would save a lot
of time for me.)

Thanks again.

-abhijit


On Fri, 16 Apr 2004, Xavier IZARD wrote:

> Abhijit Gadgil a écrit :
> > Dear All, 
> > 
> > We are facing a strange problem while loading a hex file as tbin on the 
> > TINI when the size of the file is > 64K. This problem is occuring both 
> > with the FLASH as well as RAM. This is a custom board designed by us. 
> > Further, we are not having any problems while loading hex files < 64k. 
> > 
> > When the debug and verbose mode is enabled, it is observed that the CRC 
> > check after the first of the (target bank) is loaded fails. 
> > 
> > Can anyone please throw some light on this?
> > 
> > Regards,
> > 
> > -abhijit
> > 
> 
> Hello,
> 
> I got the same problem with a custom board too (even with DTR connected 
> to reset). However, I don't know if the cause of my problem is the same 
> as for you because I load the program as hex file.
> 
> My solution is to split the hex file into smaller ones with max size of 
> 64k. Then, different parts are easy to load with a macro for javakit. I 
> wrote a C program to split the hex file, I can send it to you if you want.
> 
> Regards,

-- 
Surprises are highly over-rated.

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini