RE: Filesystem volatile
"Saim Ahmed" <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Hi, I get this error with just a serial link to my project. The system restores to its default state, and all programs erased. It happens occationally, but without warning, any help? Please Explain NVRAM Battery Voltage. The board is powered to spec. blastHeapOnReboot() is not called by my program. I run Tynamo in parrallel though, so I'm unsure where the fault lies. Any help Thanks SAIM -----Original Message----- From: tini-admin-6tN4nzCoH/[email protected] [mailto:tini-admin-6tN4nzCoH/[email protected]] On Behalf Of Bryan Armstrong Sent: 10 May 2004 16:24 To: George K. Watson Cc: tini-6tN4nzCoH/[email protected] Subject: Re: [TINI]Filesystem volatile George K. Watson wrote: > I have a pair of TSTIK/TILT-400s and each time the power is removed > and restored, the filesystem seems to get cleared. The 'default' stuff > is there, but my additions are gone. > Any clues? Two ideas: 1. Check the NVRAM battery voltage 2. Verify that TINIOS.blastHeapOnReboot() is not being called in your application. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini