External Interrupts and CAN Questions on the DSTINIs400
"Louai Al-Awami" <louai-ThMPPkGbq7hr7aOUNKNpHfd9D2ou9A/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <000d01c43bda$7f8c7fc0$2b01170a@coelouai> |
Hi all,
I am using DSTINIs400 socket with my DSTINIm400 to build some
applications. I am still exploring the boards and I would like to know the
following.
1- I discovered one pin in the data sheet called nExtInt, I tried to use
this pin with the PushButton example given in the TINI book, but the
external interrupt is not triggered. I am wondering if this is the right pin
or not. I addition, how many external interrupts are visible from the
DSTINIs400 evaluation board?
2- I am trying to find any software/hardware resources on how to operate the
CAN bus of TINI but I could not. How can I start that?
Regards
------------------------------------
Louai Al-Awami
Graduate Assistant
Computer Engineering Department
louai-ThMPPkGbq7hr7aOUNKNpHfd9D2ou9A/[email protected]
[email protected]
P.O.Box 1003, KFUPM, Dhaharn
31261, Saudi Arabia
Regards
_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini