Re: sdcc with ds400 and serial ports

Arne Gellhaus <[email protected]> Thu, 20 May 2004 17:57:13 +0200

Newsgroups	gmane.comp.hardware.microcontrollers.tini
Message-ID	<[email protected]>

Hi,

in the meantime I copied the Serial1* functions from the 390 files to my 
applications, so I can compile it. But these functions are for the real 
serial1 on the tini board, and as I want to use the 1-Wire bus too I 
cannot use serial1.

Is it possible to use serial4 with my sdcc compiled app? I looked at the 
source for the serial functions but I am not that deep in the tini 
hardware to write my own functions. Has somebody already done this or 
can provide assistance?


Regards,
Arne Gellhaus


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini