Re: Tini & Ethernet

Hi,

1.) Yes, only a network cable, but that depends of course, if you got a 
DHCP and how many computers do you want to connect to how many 
connection plugs?
That seems to me the one good reason for using a switch when using a 
tini with a dhcp!
2.) you have to configure it like it is described in chapter two of the 
"Tini Specification"
You can download it here:

http://www.maxim-ic.com/products/tini/devguide.cfm

It is very easy and should be done in half an hour properly (maybe in 
worst case 1 hour, depends on how fast you read :-)).

kind regards
Peter



Swami Venkataramani wrote:

>Hi,
>
>I have to do a TINI demo in San Diego this Sunday and I’m told that there
>will be a physical Ethernet connection as well as wireless.  I am using
>Tini1.12 and I was wondering what would be the best way to ensure that I am
>able to set up my TINI with an IP…do I need to take a network switch with
>me? Or would I just need to plug in the Ethernet cable into the TINI and use
>DHCP to get an IP? I’m not exactly sure if we will have Dynamic or Static
>IP.
>
>Any suggestions are appreciated.
>
>Thanks!
>
>Swami.
>
>
>
>_______________________________________________
>TINI mailing list
>TINI-6tN4nzCoH/[email protected]
>To UNSUBSCRIBE, edit your profile, or see list archives:
>http://lists.dalsemi.com/mailman/listinfo/tini
>
>
>  
>

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini