read state of P3.2
"Koen Swinters" <[email protected]> Fri, 21 May 2004 16:09:49 +0200
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <001001c43f3d$47601290$0202a8c0@mobiel> |
Hi All, I'm trying to read the state of P3.2 in a native methode with the following code: mov R4,0B0H mov A,#04H anl A,R4 ; When I check what is in A I get always 04H (the pin is high accorcing to this, but the pin is tied to ground). does someon know how I can read the status of a pin on the ds80C400 in a native method? regards Koen _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini