Problems when changing from 10 to 100 Mbit/s Ethernet

"HERZOG Raoul" <[email protected]> Thu, 10 Jun 2004 16:44:36 +0200

Newsgroups	gmane.comp.hardware.microcontrollers.tini
Message-ID	<[email protected]>

> Dear all,
> 
> we use DSTiniM400 & DSTiniS400.
> 
When we select jumper J10 to position 1-2 for 100Mbit/s Ethernet operation and powering up the TINI again, we don't have any Ethernet connection (no ping response any more). When we put the jumper back to 10 Mbit/s mode, it works again.

We tried everything with the PC network card, but the problem does not seem to be located there.

Any idea?
Is there no SW initialization on TINI side which must change for Mbit/s Ethernet operation?

Raoul Herzog



_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini