RE: Extreme Condition Exposure for the TINI
"Kelly Smith" <[email protected]> Fri, 11 Jun 2004 15:00:21 -0700
| Newsgroups | gmane.comp.hardware.microcontrollers.tini,gmane.spam.detected |
|---|---|
| Message-ID | <[email protected]> |
Dear Bill - I think Bob Hinton has one running in his attict (loft), in England where it gets pretty cold. And the 80C400 CPU is good for -40 degrees C (and given "conservative margins" as usually published, you could probably "push it" (but don't quote me). Just one Engineer to another, OK. I just checked Bob's TINI in England (summer temperature) and: Temperature readings at Fri Jun 11 21:56:53 GMT 2004 Fire Escape temp 25.5 C Loft temp 25.5 C Front room temp 23.0 C Best regards, Kelly Smith -----Original Message----- From: tini-admin-6tN4nzCoH/[email protected] [mailto:tini-admin-6tN4nzCoH/[email protected]]On Behalf Of Bill Smith Sent: Friday, June 11, 2004 1:45 PM To: tini-6tN4nzCoH/[email protected] Subject: [TINI]Extreme Condition Exposure for the TINI Has anybody had any experience running a TINI board in extreme temperature or humid conditions (like an attic or a crawlspace)? I have a 1-wire weatherstation that I have hooked to it and was planning on putting the TINI as close to the station as possible (like in the attic). TIA, Bill _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini