Re: java.lang.RuntimeException: Bad CRC executing .tini file

Rob Ridenour wrote:
> I am not sure how an incorrect ALE signal results in the error message that
> I have.  I would expect nothing to work correctly as it would be likely that
> many memory fetches would fail during other processes.  I was hoping the
> error message would indicate a certain address range or hardware device.  I
> believe my problem is on the address bus most likely.  I guess it could also
> be internal to the micro or something unexpected with my memory ICs.
> 
> Thanks for any ideas.

Since the module is running in non-muxed mode, the ALE is not used for 
any fetches.  I am under the impression that it will still toggle in the 
same way as muxed mode.  I don't have any insight into what might be 
going on, but pulling down the ALE signal should not be necessary for 
normal operation.  Have you checked the 3V power to the SRAMs?  Maybe 
under load something shows up that is invisible while everything is static?

-- 
--
Bryan Armstrong
bryan.armstrong-6tN4nzCoH/[email protected]

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini