Re: Target options for gcc

Hi David

Just a few minutes ago I realized that this number 5285 (somehow burnt  
into my brain) is wrong. It's the MCF5282 !!!

But thanks anyway for your help. I will check out the sites you listed.
Regards,
Bob

On Tue, 08 Jan 2008 17:43:24 +0100, Seymour David  
<[email protected]> wrote:

> Hi Bob,
> I'm assuming you mean mcf5485?   There is no mcf5285.
> http://www.freescale.com/webapp/sps/site/overview.jsp?nodeId=0127260061033202A9  
> is the link to the Freescale LTIB (Linux Target Image Builder) BSP that  
> has complete development environment that is tested too.  Not sure which  
> GCC build it has though.
> Also if you are looking for most current GNU tools chain  
> CodeSourcery.com is the place to get it.  Freescale funds them to  
> maintain and fix bugs for the ColdFire family.
> Regards,
> David
>
> David E Seymour
>
> -----Original Message-----
> From: [email protected] [mailto:[email protected]]  
> On Behalf Of Bob Brusa
> Sent: Tuesday, January 08, 2008 10:04 AM
> To: Seymour David
> Subject: [ColdFire] Target options for gcc
>
> Hi
> I recently downloaded the toolchain for Coldfire from uclinux website.  
> Its
> gcc tells me its version 4.1.1 - but hellas - gnu does not provide a
> documentation for this version. Available are 4.1.0 and 4.1.2. My  
> problem:
> Which option do I have to specify for the MCF5285 processor? Is it  
> -m5200?
> The documentation is not very conclusive.....
>
> The manufacturer of the COBRA5285-Board I am using provided examples. One
> of them uses the option -m5307 which is however nowhere documented.
>
> Best regards
> Bob Brusa
>



-- 
Bob Brusa
Chapfwiesenstr. 14
CH-8712 Stäfa
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.