RE: USB host controller

Hi Nicolas 

We currently use a Philips (NXP) ISP1632 for our host application it is
wired up to our data buss in this case we use a arm processor but it
would work with the ColdFire as well. We then bought a stack from Micro
Digital (SMX) for mass storage and mouse keyboard and some simple
printers. Our main reason for host was for thumb drives and printers the
major issue is printer support most printers are based on windows so the
drivers that you will need are somewhat difficult to say the least. We
currently use HP'S driver kit but they only support a small fraction of
there printers.


Regards Gregg

Gregg GRANVILLE
Hardware Engineering Manager
-------------------------------------
Tel 1 603.622.0212 / Fax 1 603.623.5623
[email protected] / www.metronics.com
--------------------------------------------------------
METRONICS /// 30 Harvey Road // Bedford, NH 03110-6818 / US
-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Nicolas Pinault
Sent: Thursday, March 13, 2008 4:05 AM
To: Granville Gregg
Subject: [ColdFire] USB host controller

Hi all,

I'm looking for a USB2 host controller to add to my Coldfire design. I 
have found many references.
I'd like advices to make my choice.
As I use a MCF5407 Coldfire, I don't want a PCI interface based host 
controller.
If you use such a component, any advice is wellcome.

Regards,
Nicolas


---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.

---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.