Re: USB host controller

Thank you Greg for taking time to answer my request.

Regards,
Nicolas

Granville Gregg a écrit :
> Hi Nicolas 
>
> We currently use a Philips (NXP) ISP1632 for our host application it is
> wired up to our data buss in this case we use a arm processor but it
> would work with the ColdFire as well. We then bought a stack from Micro
> Digital (SMX) for mass storage and mouse keyboard and some simple
> printers. Our main reason for host was for thumb drives and printers the
> major issue is printer support most printers are based on windows so the
> drivers that you will need are somewhat difficult to say the least. We
> currently use HP'S driver kit but they only support a small fraction of
> there printers.
>
>
> Regards Gregg
>
> Gregg GRANVILLE
> Hardware Engineering Manager
> -------------------------------------
> Tel 1 603.622.0212 / Fax 1 603.623.5623
> [email protected] / www.metronics.com
> --------------------------------------------------------
> METRONICS /// 30 Harvey Road // Bedford, NH 03110-6818 / US
> -----Original Message-----
> From: [email protected] [mailto:[email protected]]
> On Behalf Of Nicolas Pinault
> Sent: Thursday, March 13, 2008 4:05 AM
> To: Granville Gregg
> Subject: [ColdFire] USB host controller
>
> Hi all,
>
> I'm looking for a USB2 host controller to add to my Coldfire design. I 
> have found many references.
> I'd like advices to make my choice.
> As I use a MCF5407 Coldfire, I don't want a PCI interface based host 
> controller.
> If you use such a component, any advice is wellcome.
>
> Regards,
> Nicolas
>
>
> ---
> [email protected]              Send a post to the list.
> [email protected]        Join the list.
> [email protected]    Join the list in digest mode.
> [email protected]     Leave the list.
>
> ---
> [email protected]              Send a post to the list.
> [email protected]        Join the list.
> [email protected]    Join the list in digest mode.
> [email protected]     Leave the list.
>
>
>   
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.