RE: USB host controller

Hi Nicolas,

We are using a Maxim's MAX3421E which can work either as Host or Device. We
use a MCF5272. The software examples that Maxim provides are limited buy
were good enough for us to easily develop a Host that interfaces with our
USB device on (also) a MCF5272.

The MAX3421E interfaces with the MCF5272 through the QSPI port.

Martin

-----Original Message-----
From: [email protected] [mailto:[email protected]] On
Behalf Of Nicolas Pinault
Sent: Thursday, March 13, 2008 3:05 AM
To: Martin Coria
Subject: [ColdFire] USB host controller

Hi all,

I'm looking for a USB2 host controller to add to my Coldfire design. I 
have found many references.
I'd like advices to make my choice.
As I use a MCF5407 Coldfire, I don't want a PCI interface based host 
controller.
If you use such a component, any advice is wellcome.

Regards,
Nicolas


---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.

---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.