Re: MCF54455

Hi Gregg,

Granville Gregg wrote:
>
> Hi All
>
> I have started with the MCF54455 I am using VMware to compile and
> build to get the U-boot out so that I can edit it make changes I used
>
> ./ltib -p u-boot -m prep this takes the u-boot source tree out of the PKGS
>
> ./ltib -m scbuild -p u-boot Builds U-BOOT
>
> ./ltib -m scdeploy -p u-boot copy’s back to make official
>
> I am looking for the command or name of the linix image files to do
> the same with it. Dose any one have any idea what it may be and is
> there a document that explains this with a step by step procedure.
>

You can use the same steps you did for u-boot -- the package name to use
is "kernel".

A general overview of using ltib is available in the doc/ directory --
doc/LtibFaq

--Kurt
>
> Regards Gregg
>
> ------------------------------------------------------------------------
>
> **Gregg GRANVILLE**
>
> Hardware Engineering Manager
>
> -------------------------------------------------------
>
> Tel 1 603.622.0212 / Fax 1 603.623.5623
>
> [email protected] <mailto:[email protected]> /
> www.metronics.com <http://www.metronics.com>
>
> -----------------------------------------------------------------------------------------
>
> **METRONICS** /// 30 Harvey Road // Bedford, NH 03110-6818 / US
>
> [email protected] Send a post to the list.
> [email protected] Join the list. [email protected]
> Join the list in digest mode. [email protected] Leave the list. 

---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.