Debug u-boot using Codewarrior

"arun c" <[email protected]> Sat, 25 Oct 2008 05:10:19 -0400

Newsgroups	gmane.comp.hardware.motorola.microcontrollers.coldfire
Message-ID	<[email protected]>

Hi all,

I am a newbie to this coldfire world please bear with me.

I have a MCF5484LITEKIT and I downloaded the latest linux BSP for it.

To get in depth detail about u-boot I wish to do single stepping(aka
source level debug)
using codewarrior IDE ( I got a P&E BDM debugger through parallel port
along with the kit)

Can anybody tell me how to do it?

Regards,
Arun C
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.