Plz kindly respond..............

Hi,
I am stuck in running a program from DPTRAM....plz help me out..
I am using metrowerks codewarrior and Phytec MPC555 boardI am trying
to develop a custom code as a part of that I have chosen UART
function and tried to run it from DPTRAM...here is the procedure I
have adopted..

1)I have changed the function number of UART function is TPUMSKGC.ASC
function to $F and ran it using tpumasm and generated .S19 file...

2)In my program I have set RAMBAR to 0xffa0 and also have set
emulation bit,
in this context I have even mentioned in my program array of
tpurom of size 1024 and also used command "memcpy ((void *)0x302000,
tpu3rom, 4096)" as a part of configuring DPTRAM.

then i have downloaded the s19 file and tried to execute the program
but i receive no optput,I have actually run the same program
succesfully with using emulation mode...

can some one tell me where i went wrong or waht further i shall
require to run the program successfully,I went through all the
available manuals reagrding this from freescale website but couldnot
make out ....

regards,
Sasanka.G.V






-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/