linking TPU channels...
"Dan Fowell" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <000501c55d5b$dc0f1430$5e0a010a@RED> |
A quick question on the TPU. Is there some way to link TPU channels in
software so that you can run different functions on different channels all
based on the input to one channel? I want to share a single encoder
signal with multiple TPU channels and run NITC and FQM functions on them,
but I would like to avoid adding wire jumpers if possible. Right now our
encoder signal (after isolation) goes directly to a specific TPU channel.
Is what I would like to do possible without physically jumpering channel
inputs together?
Thanks for any help!
Dan
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/